Description
The 650*340*80 rainwater inlet grating made of high-strength polymer composites is designed to receive surface waste water in the curb zone of low-volume motorways and car parks. This grating is ideally suited for installation in the already existing cast iron or plastic shell in the roadway. The material used for manufacturing is resistant to aggressive media, salt solutions, acidic and alkaline media. Conforms to technical conditions DSTU B B.2.5-26:2005, European standard EN 124-6:2015 and TU U 25.2-31642900-004:2009. The certificate of conformity is available.
SKU:
137
Out of stock

Inlet grating 650*340*80

Minimal quantity available to order: 5
Leave a request
exc.VAT
€20.90
Class B125
Rated load capacity 6 t
Maximum load 10 t
Cross-sectional area 0.063 m²
Length 650 mm
Hole 252x43 mm - 6 pieces
Heights 80 mm
Width 340 mm
Mass 9 kg
Custom Solutions
  • Easy customization of color, logo, patterns, and add locks.
  • Manufacturing manholes with various sizes, shapes, etc.
Learn More

Please leave a request, and we will contact you

What our clients say
A smart choice for modern interiors
I needed something sleek and low-profile for a commercial showroom project. These panels sit flush with the surface and match the floor finish perfectly. Clients barely notice they’re there — exactly what we wanted.
Huge time saver for my crew
We used to spend a ton of time just lifting and resealing old hatches. These new ones pop open in seconds and don’t require tools. That alone has cut down service times big time.
No rust, no worries
Living near the coast, metal covers would always corrode in a year or two. These ones? Still look brand new after 18 months. Super easy to install and they just blend into the space.
Lightweight but solid
We switched to these plastic access covers for a housing project last year and never looked back. Lightweight enough to carry solo, but surprisingly strong — we’ve had forklifts roll over them with no issue. Clients love the clean look too.